Tripp Lite 12-Port Wallmount Cat5e Patch Panel 568B, RJ45 Ethernet(N050-012)
Network closets do not always have room for a full floor rack. We built this wall-mount patch panel to terminate your drops right against the wall board, keeping terminations solid and out of the way. It gives you a clean field of ports where patch cords can land without clutter.
Price as the listing last showed it. Listings move, so the figure on the page you land on is the one that counts at checkout.
- 12-Port Cat5e Wall Mount Patch Panel 568B
- Easy wallmounting with included 89B bracket
- 110 Punch down on rear of panel
- Metal frame, includes mounting bracket
How this one is built
Included wall bracket
The bracket mounts straight to plywood backboards or wall studs. Once the bracket is anchored, the panel snaps into place so you can route bundles cleanly from above or below without fighting awkward angles.
Rear punchdown blocks
Punchdown points on the back side accept solid conductor cabling. The layout leaves room for your punch tool to seat each pair cleanly, holding wire position through years of moves and changes.
Metal frame
The panel uses a rigid metal frame that will not bend while you punch down wires. That backbone keeps port spacing square and stops the board from flexing when patch cables get plugged in hard.
Front port layout
RJ ports sit in an orderly row across the front face. Labels stay readable once cords are plugged in, making it straightforward to trace a run back to an office drop or access point.
On the nameplate
These are the figures published for this unit. Where a number is missing here it was not printed on the listing, and we would rather leave the row out than fill it with a guess.
| Color | 0 |
|---|
Others from patch panels
Sorted by how many people have rated them.
