Tripp Lite 36-Port LC/LC Rackmount Fiber Enclosure Feed Thru Patch Panel
Fiber runs coming into an equipment room need a clean place to terminate before you patch over to switches. This steel enclosure bolts into standard racks and holds rows of feed-through couplers. You plug patch cords straight into both sides without splicing inside the tray.
Price as the listing last showed it. Listings move, so the figure on the page you land on is the one that counts at checkout.
- 36 port LC/LC Feed Through couplers in a 1U panel ( 3 x 12port modules )
- Supports Single mode or Multimode Fiber connections
- 19" Wide x 8" Deep x 1.75" High
- Pull-out locking tray for easy access to internal connections
- Heavy Cold-Rolled steel construction, Black Powder Coated finish
How this one is built
Sliding steel tray
The interior drawer pulls forward on slides so you can inspect connections or route fresh strands. It locks back into the chassis when you finish work, keeping sensitive fiber jumpers shielded inside the rack.
Feed through couplers
LC couplers on the front face connect directly through to the rear ports. You plug factory-terminated trunk lines into the back and run jumpers off the front, skipping the splice trays and heat shrinks entirely.
Steel chassis build
We form the enclosure from heavy cold-rolled steel and finish it with a black powder coat. It mounts solidly to standard rack rails without sagging under the weight of bundled optical cable.
Rear cable entries
Cutouts across the back of the chassis let fiber trunks enter smoothly from either side of the rack. That keeps bend radiuses wide and stops tight jackets from pinching against sharp sheet metal edges.
On the nameplate
These are the figures published for this unit. Where a number is missing here it was not printed on the listing, and we would rather leave the row out than fill it with a guess.
| Color | Black |
|---|---|
| Weight | 6 pounds |
Others from patch panels
Sorted by how many people have rated them.
