Tripp Lite P120-001-2 Adapter/Splitter Cable
Splitting an analog video feed from a graphics card should not mean loose adapters hanging off the back of the tower. We built this cable to break out a single DVI-I output into two standard VGA connections. It sends an identical picture to two screens side by side across a workstation.
Price as the listing last showed it. Listings move, so the figure on the page you land on is the one that counts at checkout.
- Connect two VGA monitors to a single DVI-I port
- Double shielded and fully molded construction
- Tripp Lite Lifetime Warranty
How this one is built
Molded connector ends
The plug hoods are molded directly over the terminals to resist strain where the cable drops down behind a workstation desk. Thumbscrews hold the connection firm against vibration and accidental tugs.
Double shielded jacket
Tinned copper braid over foil shielding runs the length of the assembly. It blocks noise from nearby power lines, fluorescent ballasts, and desktop power bricks from bleeding into the analog raster.
Splitter leg spacing
The two breakout legs allow separate routing to adjacent monitors on a shared mount or desk. Both ends use standard female hardware so existing monitor runs plug straight in.
Matte black jacket
A dark outer jacket blends into the bundle behind your equipment rack or monitor arm. It stays flexible enough to route through tight cable management channels without kinking.
On the nameplate
These are the figures published for this unit. Where a number is missing here it was not printed on the listing, and we would rather leave the row out than fill it with a guess.
| Connector | Component |
|---|---|
| Color | Black |
| Weight | 5.6 ounces |
| Warranty | Lifetime limited warranty |
Others from video and A/V
Sorted by how many people have rated them.
