Tripp Lite Series 3ft USB-C to 3.5mm Audio Cable Type-C to AUX Cord for Car Headphone Jack
Modern phones dropped the headphone jack, but plenty of vehicles, powered speakers, and bench receivers still rely on one. We built this cord to bridge that gap without an extra dongle dangling in the middle. It runs straight from the USB port to the audio input with clean signal passing through.
Price as the listing last showed it. Listings move, so the figure on the page you land on is the one that counts at checkout.
- FULLY SUPPORTED & PROVEN QUALITY: This product is protected by a Manufacturer's 3-Year Limited Warranty. To best support your purchase, Eaton's expert technical team is available via phone, web, or email to address any concerns.
How this one is built
Molded strain relief
The ends take daily bending near the phone port and the dashboard jack. We mold the boots directly over the internal solder joints so pulling the cord loose does not pull the wires out of the pins.
Reversible plug barrel
The upstream end plugs into your device either way up. It seats firmly inside the port housing without wobbling loose over rough roads or when you pick the phone up off the console.
Direct audio line
This cable bypasses the need for stacked adapters and loose splitters. You get a single run between the source and your mixer, car receiver, or studio monitor without extra connection points adding noise.
Flexible outer jacket
The outer jacket lays flat across a dash or workstation without stiff coiling. It packs down into a glove box or tool pouch and unrolls without holding memory bends.
On the nameplate
These are the figures published for this unit. Where a number is missing here it was not printed on the listing, and we would rather leave the row out than fill it with a guess.
| Color | Black, Gray |
|---|---|
| Weight | 0.88 ounces |
Others from USB hubs and docks
Sorted by how many people have rated them.
