Tripp Lite T1 Shielded RJ48C Cross-over Cable (RJ45 M/M), 5-ft. (N266-005)
Direct connections between telecom gear and CSU/DSU hardware require the transmit and receive lines to cross over cleanly. We build this shielded patch cable in a beige jacket to handle those links inside the cabinet or across the telco board. Connectors on both ends seat firmly and hold their ground.
Price as the listing last showed it. Listings move, so the figure on the page you land on is the one that counts at checkout.
- 5-ft. T1 Shielded RJ48C Cross-over Cable (RJ45 M/M)
- 22AWG, 100ohm T1 Rated Cross-over Cable
- Connects your T1 CSU/DSU
- Meets ANSI T1.403 Cabling Requirement
- Compliant with the Federal Trade Agreements Act (TAA) for GSA Schedule purchases
How this one is built
Internal wiring layout
Pins cross over internally so two network endpoints talk straight to one another. That allows a direct link between interface cards or into a CSU/DSU without patching through an active hub.
Shielded cable jacket
The outer shield helps quiet noise from adjacent power lines and nearby equipment racks. It covers the conductor bundle right up to the molded modular plugs at each end.
Connector strain relief
Molded ends support the conductors where the assembly flexes most. The modular plugs snap into standard network jacks and stay put until the latch is released by hand.
Federal schedule compliance
We assemble this crossover patch cord to meet TAA requirements for government purchasing. It drops right into standard telecom frames, server enclosures, and wall-mount brackets.
On the nameplate
These are the figures published for this unit. Where a number is missing here it was not printed on the listing, and we would rather leave the row out than fill it with a guess.
| Connector | RJ45 |
|---|---|
| Color | Beige |
| Weight | 2.4 ounces |
| Warranty | Lifetime limited warranty |
Others from ethernet cables
Sorted by how many people have rated them.
