Tripp Lite 2400 Watt 24 Volt DC/120 Volt AC Inverter
Server racks need cabling that sits right and stays seated. We build this power cord with heavy gauge copper to bridge the distance between wall receptacles and your rack hardware. It drops into crowded wire managers without binding, giving your gear the continuous feed it demands.
Price as the listing last showed it. Listings move, so the figure on the page you land on is the one that counts at checkout.
How this one is built
Heavy gauge copper
Thick conductors carry the current without building excessive heat during continuous operation. The internal wire handles steady draw from servers, switches, and distribution units over long shifts without sagging under load.
Molded plug ends
Factory molded connectors resist strain right where the cord exits the wall box or equipment inlet. The solid termination keeps internal pins aligned through routine maintenance pulls and cabinet reorganizations.
Flexible outer jacket
A durable exterior casing resists abrasion from rack rails and other dropped runs. It bends clean corners through cable ladders without pinching the underlying conductors or splitting over years in closed closets.
Clean rack routing
The jacket stays supple enough to lay flat against uprights and lace into vertical managers. That keeps the back of your cabinet clear so exhaust air moves freely away from hardware.
On the nameplate
These are the figures published for this unit. Where a number is missing here it was not printed on the listing, and we would rather leave the row out than fill it with a guess.
| Outlets | 2 |
|---|---|
| Watts | 2400 W |
Others from power cords
Sorted by how many people have rated them.
