Tripp Lite Heavy Duty Power Cord, 15A,14AWG (NEMA 5-15P to IEC-320-C15) 4-ft.(P019-004)
Heavy network switches and server chassis pull steady current all day. We build this power cord with heavy-gauge conductors and molded connectors to take that draw without heating up. It links gear with standard input connections to nearby source outlets without slack cluttering the rack floor.
Price as the listing last showed it. Listings move, so the figure on the page you land on is the one that counts at checkout.
- Connect network hardware with C15 power connections such as Ethernet switches, to outlets with 5-15R type inputs
- 4-foot heavy-duty power cord supports up to 125V
- 125V, 15A, 14AWG, SJT, UL-listed
- Use with Cisco, HP and other hardware that uses C15 type power connections
- Lifetime Limited Warranty
How this one is built
Molded plug ends
The terminations are molded directly over the conductors with integral strain relief. They resist bending fatigue behind server rails and hold firm in the receptacle when other cables get pulled past them.
Heavy jacket build
Thick insulation encases the internal conductors to withstand the friction of crowded raceways and wire baskets. It routes cleanly through vertical cable managers without kinking or flattening under light bends.
Hardware connection fit
The connector end fits directly into network switches, routers and storage hardware from major manufacturers. It stays seated through vibrations from cooling fans and nearby equipment drawers.
Clean rack routing
The run gives you enough reach to bridge the gap between your switch and a distribution unit. It keeps extra bulk out of the rear exhaust path so air moves freely.
On the nameplate
These are the figures published for this unit. Where a number is missing here it was not printed on the listing, and we would rather leave the row out than fill it with a guess.
| Color | Black |
|---|
Others from power cords
Sorted by how many people have rated them.
