Tripp Lite Metered PDU, 30A, 48 Outlets (8 C19 and 40 C13), 208/240V, L6-30P, 10 ft. Cord
Cabinet rails fill up fast once you start dropping in switches and compute nodes. We built this metered power distribution unit to take one main AC line into the rack and break it out across equipment across separated banks. Built-in breakers defend the outputs so one tripped bank does not take down the whole frame.
Price as the listing last showed it. Listings move, so the figure on the page you land on is the one that counts at checkout.
- Distributes 30A single-phase AC power to as many as 48 servers, routers, switches and other networking rack equipment
- Dual load banks with 24 outlets each (4 C19 and 20 C13)
- Dedicated 20A circuit breakers protect output
- NEMA L6-30P input plug with 10-ft. (3 m) cord
- 2-year limited warranty
How this one is built
Dual load banks
Output outlets are split across two distinct banks. This arrangement helps balance gear across the feed and keeps line loads manageable when heavy switch stacks or multi-cord servers draw at once.
Dedicated circuit breakers
Independent breakers sit right on the chassis for the output groups. If an individual bank draws past its limit, the breaker trips there while the adjacent bank continues to supply line voltage to hardware on it.
Heavy input lead
A long input cord with a locking plug runs out the rear of the chassis. It reaches floor drops or overhead busways without demanding extensions or awkward routing across neighboring cabinet bays.
All-metal chassis
We house the distribution hardware in an all-metal enclosure built for equipment racks. The casing mounts securely to the rails, giving plugs a firm seat that will not flex when cords get dressed and bundled.
On the nameplate
These are the figures published for this unit. Where a number is missing here it was not printed on the listing, and we would rather leave the row out than fill it with a guess.
| Weight | 12.35 pounds |
|---|
Others from rack PDUs
Sorted by how many people have rated them.
