Tripp Lite Rack Enclosure Horizontal Cable Manager Steel with Finger Duct 2URM SRCABLEDUCT2UHD
Patch cords hanging straight down from a dense switch panel eventually pull on their own jacks. We build this horizontal manager with slotted fingers and a dual-hinge cover to carry those bundles across the frame. It mounts directly into standard rack rails to keep runs tidy between patch fields.
Price as the listing last showed it. Listings move, so the figure on the page you land on is the one that counts at checkout.
- 2U 19-inch High Capacity Horizontal Cable Manager -finger duct with dual-hinge cover
- Helps eliminate cable stress
- Organizes cables within SmartRack enclosure or open rack
- Required mounting hardware included
- Cold rolled steel with black finish
How this one is built
Steel trough construction
We stamp the main body from cold rolled steel and coat it in a black finish. The metal stays rigid when loaded with thick bundles of network patch cords, so the channel does not sag across the span.
Slotted finger duct
Molded fingers line the front of the channel with wide spaces between them. You can peel individual patch cords out right at the port they feed without kinking copper conductors or bending fiber past its limit.
Dual hinge front cover
The front door snaps onto the duct fingers and swings open from either the top or bottom edge. You can service a run without taking the cover off entirely, or lift it away when dressing new drops.
Standard rail mounting
The unit bolts into the front or rear rails of an open frame or a floor enclosure. We include the mounting hardware in the package so you can bolt it into place right out of the box.
On the nameplate
These are the figures published for this unit. Where a number is missing here it was not printed on the listing, and we would rather leave the row out than fill it with a guess.
| Color | Black |
|---|---|
| Weight | 1 pounds |
Others from racks and cooling
Sorted by how many people have rated them.
