Tripp Lite SATA to eSATA Transition Cable (7Pin/18-In.(P952-18I)
Storage drives running outside a desktop chassis still need a direct line to the motherboard. We built this transition cable to link an internal board connector to an external drive housing. The jacket shields the signal pairs from nearby interference inside crowded tower cases.
Price as the listing last showed it. Listings move, so the figure on the page you land on is the one that counts at checkout.
- Sata internal "L" To external eSATA "I" Cable - 18 in.
- Supports data transfer Rates of up to 6.0 Gbps
- Cable is shielded to protect against EMI/RFI line noise
- Lifetime warranty
How this one is built
Molded transition ends
One end uses the keyed internal shape while the other seats into external enclosures. The moldings seat firmly so drives stay mounted through vibration.
Shielded signal run
Foil shielding surrounds the data lines along the reach between ports. That shielding helps isolate the data stream from nearby power lines and chassis fans.
Chassis pass through
The flexible jacket routes out of the computer casing without binding against the metal edges. It leaves enough slack for service work inside.
Red jacket finish
The bright color stands out immediately against dark motherboard trays and backplanes. It helps tech teams trace drive paths during maintenance.
On the nameplate
These are the figures published for this unit. Where a number is missing here it was not printed on the listing, and we would rather leave the row out than fill it with a guess.
| Connector | Sata |
|---|---|
| Color | Red |
| Weight | 27.22 g |
| Warranty | Lifetime limited warranty |
Others from power cords
Sorted by how many people have rated them.
